BAHRAIN MOTORS COMPANY WLL
A period of two months was allotted to conduct a pilot on a 2017 CAT 700 Generator. The results of this pilot were extremely positive. A saving of 6.7% in fuel usage under normal operating condition. During 24-hour operating condition a savings of 8.63% in fuel usage was realized. Savings will also increase in time due to the maintenance decreasing.
View Case Study
STAYBRIDGE HOTEL
After a 9 month intensive testing program, it was clear that DS-600i reduced fuel consumption on the boilers by 15.5%.
View Case Study
MANATOWOC 4600 DRAGLINE
A Manatowoc 4600 Dragline was being used by the Florida Crushed Stone company to excavate limerock under water. Previous normal operations burned 22.5 gallons per hour of fuel and after treating the fuel with DS-600i, after fuel consumption leveled, it remained at 17.8 gallons per hour which is a 20.9% decrease in fuel consumed.
View Case Study
CAT D10T C27
We worked with a certified CAT rebuild center that overhauls and rebuilds large Cat engines. After every overhaul and rebuild these Cat engines go through rigorous testing to validate peak performance through an engine dyno and tune.
View Case Study
WALMART TEST
Walmart conducted a five-month test using DS-600i at their Brooksville, Florida terminal. The test fleet saw a significant increase in fuel economy. Drivers also noted increased power, better engine performance, and reduced particulate emissions.
View Case Study
ASTEC INDUSTRIES DOUBLE BARREL ASPHALT PLANT
McCartney Construction conducted a carbon mass balance test on its ASTEC industries, Inc. Double Barrel Asphalt Plant and confirmed that the addition of DS-600i to the fuel will reduce not only fuel consumption, but harmful emissions as well.
View Case Study
CUMMINS ENGINE
Savage Industries located in American Fork, Utah began using DS-600i on their Cummins diesel engines and saw two primary benefits: cost savings and engine maintenance.
View Case Study
DAVIS COUNTY SHERIFFS OFFICE
The Davis County Sheriff’s Office had tested other fuel additives without success. They were skeptical that our product would work. However, the Sheriff’s Office did test it and saw a 15.43% increase in fuel efficiency during the test. This resulted in a projected 14.18% savings in fuel costs.
View Case Study
DRILL RIG
Bill Barrett Corporation started using DS-600i in May 2008. They measured an increase drill time (hours per gallon) that equated to a savings of 16.3%.
View Case Study
CAT 3412, 773B, D-342, D8K ENGINES
Southern Aggregates is a mining a concrete operation in Augusta, Georgia. While using DS-600i they experience very promising results. Southern Aggregates realized gross fuel savings of 7 – 8%. They also reported that upon inspection of engines that the product was tested on, they found zero carbon build up. This was verified with oil analysis by their lubricants supplier.
View Case Study
MINING OPERATION
We received a letter from Jim Laughland, who is the supervisor at American Aggregates’ underground limestone mine in Indianapolis, Indiana. Jim wrote to us to share the results of a seven month test of the product in American Aggregates’ mining equipment.
View Case Study
PETERBILT 379
Dick Glaze, Route 66 Logistics, Inc., began using DS-600i in the fuel for his Peterbilt truck. He said, “I began adding it at each fueling and I can report that the carbon build-up has decreased…and my engine has shown an increase of 1.0 mpg [15.4% increase].”
View Case Study